1HD-FTE Forward Facing Intake Manifold

1HD-FTE Forward Facing Intake Manifold

Your factory intake manifold is modified to have a forward facing inlet.

WE REQUIRE YOUR FACTORY INTAKE TO COMPLETE THE WORK. PLEASE READ THE LISTING DESCRIPTION PRIOR TO ORDERING. NO REFUNDS WILL BE ISSUED FOR FAILING TO READ THE PRODUCT DESCRIPTION & NOT SENDING YOUR INTAKE MANIFOLD IN TO US!!!

Features:

• 3″ inlet with maximum possible intake volume without interfering with the factory injector lines & mounts
• Retains all factory injector line clamps/mounts
• Port for MAP sensor boost reference & air intake temperature
• Larger internal displacement than factory
• Tested with zero pressure drop from cylinder 1 to cylinder 6
• Welded in a jig to ensure 100% perfectly flat mating surface even after modification
• OPTIONAL Powder-coating and/or ‘ TURBO ‘ decal

These intake manifolds utilise the lower half of the factory intake. We require your intake manifold to complete the work. Please send us your intake with your order number (after purchasing) and we will modify it and send it back. Typically this takes 1-2 weeks depending on cleaning, welding and powder-coating lead times.

YOUR INTAKE MUST BE SENT TO: 1/3 Page Street, Kunda Park, 4556. With a copy of your name & order number.

If your intake manifold is off a HDJ100, the power steering reservoir will still bolt to the same factory location on the side of the intake. If your intake is off a HDJ79 where the power steering reservoir mounts to the front of the intake manifold, it will need to be relocated to the side, similar to the HDJ100 reservoir position. This can be done by modifying your 79 series reservoir or purchasing a 100 series or aftermarket one.

Note: This intake may be more suited to 100 series / 80 series / FTE converted patrols etc. HDJ79’s have a very tight engine bay and fabricating a cold side intercooler pipe may be more difficult with a forward facing intake.

Before we can perform any welding work on your intake manifold, it must be thoroughly cleaned of all carbon build-up, sludge, and oil deposits. Dirty manifolds can significantly compromise weld quality. If your intake manifold arrives uncleaned, we will need to send it to be cleaned which will be done so at your cost. To avoid additional charges and delays, we strongly recommend that customers properly clean their intake manifold before sending it in to us.

This is an aftermarket part, manufactured by HyperFab and is not designed to replicate a genuine replacement part.